Pro-Cut KG-32-XP Meat Grinder (#32 head)

Stainless Steel Meat Grinder Plates (reversible). The outer edge of each plate has three half-moon cut out notches. The kidney plate has three kidney bean shaped holes.

注意:刀和板开发一个交配穿pattern as they operate together (same as a piston in an engine cylinder sleeve), so it's important to always keep them together as a set. When you reverse the plate to use the new side, use a new knife. Using an unmatched knife/plate set will cause bad performance, rapid wear and possibly breakage. So you will...

Stainless knives and carbide knives work the same except carbide will wear longer. Both are resharpenable.

注意:刀和板开发一个交配穿pattern as they operate together (same as a piston in an engine cylinder sleeve), so it's important to always keep them together as a set. When you reverse the plate to use the new side, use a new knife. Using an unmatched knife/plate set will cause bad performance, rapid wear and possibly breakage. So you will normally want to have two blades for every plate.

Available...

Three sizes available: 5/8" (15mm), 1" (25mm) and 1-3/8" (35mm) outside diameter. The inside diameter measurements are: 7/16" (11mm), 3/4" (19mm) and 1-1/4" (32mm). Tubes are HD plastic and have very little taper. Use the 1-3/8" tube to fill fibrous casings and old fashioned middles. The 1" tube is great for filling hog casing or 32mm collagen. Use the 5/8" tube for snack sticks and breakfast sausage. 5/8" tube will fit 19mm and 21mm casings.

我们还提供了一个a 2 inch aluminum tube.

LEM 2" aluminum stuffing tubes fit the LEM Big Bite grinders. Note this is the inside diameter measurement. The outside diameter measures 2-1/4" (57mm).

Heavy Duty 220v Foot Switch: This foot switch can be used to turn on/off our 220 volt single phase meat grinders, allowing operator free use of hands. Especially useful when stuffing sausage. Ruggedly built for long life with cast iron housing, nonskid base pad and molded nylon actuating cam. This foot switch is NOT PREWIRED, and installation requires electrical skills. Switch is momentary type, meaning that, when properly wired, power is supplied to meat grinder while pedal is held down and power is cut off when pedal is...

This nylon washer will fit the auger shaft or worm gear shaft on the Torrey M32 meat grinders and the ProCut KG-32, 32-MP and 32-XP meat grinders. 1-7/8" OD. 1-1/4" ID. 1/4" thick.